Jeep E-60 owner manual Model Condition Possible Cause Correction

MODEL	CONDITION	POSSIBLE CAUSE		CORRECTION
All	Plow will not hold in	1. Air in cylinders and hoses.		1.	Bleed cylinders and hoses. Tighten P.A.
Power	angled position.				cylinder gland nut.
Angling		2.	Leaking “C” cartridge O-rings.	2.	Replace O-rings.
Models		3.	Leaking or open pilot check valve.	3.	Clean or replace pilot check valve.
		4.	Leaking crossover relief valve.	4.	Clean or replace crossover relief valve.
		5.	Crossover relief valve opening at	5.	Replace crossover relief valve.
			too low a pressure.
All	Motor does not operate.	1. Discharged or defective battery.		1.	Recharge or replace battery.
Power		2.	Loose or corroded electrical connections.	2.	Clean and tighten electrical connections.
Angling		3.	Inoperative starter solenoid.	3.	Replace starter solenoid.
Models		4.	Malfunctioning control switch.	4.	Replace control switch.
		5.	Malfunctioning motor.	5.	Repair or replace motor.
All	Plow does not lower.	1. No current to “A” coil. (black wire)		1.	Locate malfunction and repair.
Power		2.	“A” cartridge jammed in closed position.	2.	Clean or replace “A” cartridge.
Angling		3.	Inoperative “A” coil. (black wire)	3.	Replace “A” coil. (black wire)
Models
All	Plow creeps down.	1. Leaking “A” cartridge.		1 Clean or replace “A” cartridge.
Power		2.	Leaking “A” cartridge O-ring.	2.	Replace O-ring.
Angling		3.	Leaking “B” check valve.	3.	Clean or replace “B” check valve.
Models		4.	Leaking ram packing cup.	4.	Replace ram packing cup.
		5.	Leaking O-ring at bottom of lift cylinder.	5.	Replace O-ring.

22