Jenn-Air 8101P549-60 the top of the warming drawer cut- out, When Installing Below A Wall Oven

WHEN INSTALLING BELOW A WALL OVEN

Warming drawers are suitable for installa- tion below only certain specified wall oven models.

INSTALLATION BELOW A SINGLE OVEN

231/2"	*NOTE: Additional clearance between cutouts may
Min.
	be required. Check to be sure that oven supports
	above the warming drawer location do not obstruct
	the required interior 231/2" depth and 91/4" height.

See the label attached to the top of the warming drawer for suitable models.

Drawer overlaps will conceal cut edges on all sides of the opening.

The rough opening for the drawer must be:

¥ Depth: 23-1/2" minimum from inside back

to front of cabinet frame.

2 x 2 or 2 x 4 anti-tip block againstrear wall 9"from floorto bottom ofblock

Oven

cutout

9”

91/4"

2”

Min.

Allow 5/8"

overlap on

all sides

231/4"

101/2"

¥	Width: 28-1/2"
¥	Height: 9-1/4"
¥	Allow 2" minimum between oven and
	drawer cutouts for clearance of over-
	laps.

281/2"
1" Min. above toekick or adjust	30"
to oven installation height

INSTALLATION BELOW A DOUBLE OVEN

NOTE: If you are installing in frameless cabinets, it may be necessary to install 1/2" wide cleats to accept drawer mounting screws. See drawer to find exact locations of mounting screws.

NOTE: Electrical receptacle can be in- stalled as shown for countertop installa- tions. Do not install receptacle above

the top of the warming drawer cut- out.

231/2" Min.

Oven

cutout

2 x 2 or 2 x 4 anti-tip
block against rear
		9	”
wall 9" from floor to
bottom of block	91/4"

*NOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 231/2" depth and 91/4"height.

Allow 5/8" overlap onall sides

2” Min.

231/4"

101/2"

281/2"

1" Min. above toekick 30"

4