SPECIFICATIONS AND REQUIREMENTS, CONT.
PROVIDE CABINET SUPPORT
IMPORTANT: When installed below a single or double oven, check to be sure that any oven supports above the cutout do not obstruct the
2" x 4" or equivalent runners
231/2"
25"
30"
¥A 2" minimum clearance between oven and warming drawer cutouts is required. Additional clearance may be required if 2" x 4" blocks are used to support runners or solid floor of the oven above.
¥The warming drawer may be supported by either a solid bottom, 2" x 4" or 2" x 2" runners.
¥The support must be level and rigidly mounted, flush with the bottom edge of the cutout.
¥There is no way to level the drawer once it has been installed. Be sure supports are level.
¥The entire weight of the drawer is sup- ported by the runners or solid floor. They must be capable of supporting 150 lbs.
ANTI-TIP BRACE
WARNING
¥An
¥Before installing
Install a 2" x 4" or 2" x 2" anti tip brace 9" above the runners and against the rear cabinet wall no more than 23" back from the face to the cabinet frame.
9"
2" x 4" or runners
or solid bottom
INSTALLING THE
DRAWER
1.Slide the left corner into opening and push power cord into the hole leading to the outlet location. Thread the cord through as drawer is being pushed back into the opening.
If the outlet is installed inside the open- ing, plug the cord into the outlet. Coil power cord and install it in the clip on the right side of the unit. Make sure the cord does not get trapped by the drawer.
NOTE: Insure that the power cord does not contact the hot surfaces on the bottom of ovens, cooktops, or any other appliance.
2.Push the drawer back until the front flange is flush to the cabinet front.
3.Open the drawer fully.
4.Drill pilot holes through the holes in the overlapping frame, one on each corner.
5.Drive wood screws provided into each corner.
IMPORTANT: Do not operate the Warming Drawer if the decorative front kit has not been installed.
5
