Storage
******+******************j**************44444444444
Cleaning Under the Refrigerator
Your refrigerator can be rolled out for cleaning the floor underneath. Raise the leveling feet if engaged (see page 3). Pull the refrigerator straight out from the wall.
Vacations
If you will be gone for a month or less, leave the controls at the usual settings.
During longer absences:
4remove all food,
b)shut off the ice maker (if installed) and the valve where you tapped into the water line to supply the refrigerator,
c)disconnect the refrigerator from the electrical outlet,
4remove the filter cartridge (certain models) and install the filter bypass (see page
and Maintenance 1’81
cartridge. A new cartridge can be installed when the refrigerator is put back in service.
Note: Disconnecting power to the refrigerator will sus- pend the 12 month countdown for the water filter change reminder (select models).
e)clean and dry the refrigerator thoroughly,
f)leave the doors open to prevent odors.
Moving
When moving, follow steps
Replacing a Light Bulb
a CAUTION: Disconnect the power cord before replacing light bulb(s). Wear gloves as
protection against possible broken glass.
Always use a standard 40 or 60 watt appliance bulb when replacing a fresh food or freez-
er compartment bulb.
Refrigerator
There are two light bulbs located at the top of the refriger- ator compartment, on the underside of the Twin Fresh”’ control housing.
To replace a lightbulb( remove the control cover from the control housing:
grasp the control cover at the two rear “finger tabs”. These are located at the upper rear of the fresh food compartment, behind the light shields.
pull down slightly to clear the retainer tabs and slide the cover forward until it is free.
replace the bulb(s) with a
After replacing the bulb(s), align the control cover on to the ribs on the control housing and slide it straight back until it snaps onto the retainer tabs.
On certain models, there is an additional light located behind the top drawer. To replace:
lremove the top drawer and cover as explained on page 10.
lcarefully reach into the bulb cover and unscrew the lightbulb.
lreplace the bulb with a
Freezer
The freezer light is located on the back wall of the freezer compartment.
To replace:
unhook the tabs on the top of the light shield by press- ing in with the thumb on the center top of the light shield.
pivot the shield down.
unscrew the bulb when cool and replace it with a stan- dard
replace the bulb cover by pivoting it back into place and snapping the tabs into the appropriate slots.
Dispenser Light (dispenser models only)
To replace:
lLocate the lightbulb in the dispenser area to the left of the actuator.
lUnscrew the used bulb and remove.
lReplace the bulb, using a
