Jenn-Air JMD2124 Clock, Start, Add 1 Minute, Stop/Clear, Timer, Tones, Control Lock, Setup, Help

Models: JMD2124

1 32
Download 32 pages 19.57 Kb
Page 6
Image 6
Clock

Clock

This is a standard 12-hour clock (12:00-11:59).

To Set Clock:

1.Touch TIMER/CLOCK, then number pad 2.

2.Enter time in hours and minutes.

3.Touch TIMER/CLOCK again to complete the setting.

Start

The START control (START/ADD 1 MINUTE) begins any cooking function. If cooking is interrupted, touching START control will resume the preset non-sensor function.

NOTE: To avoid unintentional operation of the microwave oven, START control will work only if a cooking cycle has ended, the drawer has been closed or the STOP control has been touched within the past 3 minutes.

Add 1 Minute

The ADD 1 MINUTE control (START/ADD 1 MINUTE) starts the microwave oven at 100% power for 1 minute. Each additional touch of the control will add 1 minute of cook time.

Cook time may be added in 1-minute increments to a cooking cycle at the current power level by touching ADD 1 MINUTE during the cycle. The Add 1 Minute function cannot be used during Reheat, Defrost or any sensor cycles.

NOTE: To avoid unintentional operation of the microwave oven, the ADD 1 MINUTE control will work only if a cooking cycle has ended, the drawer has been closed or the STOP control has been touched within the past 3 minutes.

Stop/Clear

The Stop control (STOP/CLEAR) clears any incorrect command, pauses cooking and cancels most functions with one touch of the control. Touch STOP twice to cancel a running cooking cycle.

The microwave oven will also turn off when the drawer is opened. Close the drawer, and touch START to resume the non-sensor cycle.

Timer

The Timer can be set in minutes and seconds, and counts down the set time.

NOTE: The Timer does not start or stop the microwave oven.

To Set Timer:

1.Touch TIMER/CLOCK, then number pad 1.

2.Enter time in minutes and seconds.

3.Touch TIMER/CLOCK again to start Timer.

Timer may be canceled at any time by touching STOP.

Tones

End of Cycle Tones

Tones sound at the end of any cooking cycle, unless turned off.

To Turn Off/On Sound: Touch SETUP control twice, then touch

START.

Reminder Tones

Tones sound every 10 seconds for 1 minute, then every 3 minutes up to 1 hour. Touch STOP to stop the tones.

To Turn Off/On Reminder: Touch SETUP 3 times, then touch

START.

Control Lock

The Control Lock shuts down the control panel pads to avoid unintended operation of the microwave oven. When the control is locked, only the CONTROL LOCK control will function.

To Lock/Unlock Control: Touch and hold CONTROL LOCK for 3 seconds. The display will indicate the lock status.

Setup

The SETUP control (SETUP/HELP) provides access to the following settings:

Tones - sound off or on. See “Tones.”

Reminder tones - remind signal off or on. See “Tones.”

Auto start - See “Auto Start” in the “Microwave Oven Use” section.

Demo Mode - demo on or off. See “Demo Mode.”

Demo Mode

The Demo Mode is ideal for learning how to use the microwave oven. When the Demo Mode is active, functions can be entered, with real displays and tones, without actually turning on the microwave generator (magnetron). While functions are operating in Demo Mode, the light comes on, and the display counts down the time quickly.

To Activate Demo Mode: Touch SETUP 5 times, then touch and hold START for 3 seconds.

To Deactivate Demo Mode: Touch SETUP 5 times, then touch

START.

Help

Tips are available for all automatic functions. To view tips, touch HELP (SETUP/HELP) while “HELP” is lit in the display.

6

Page 6
Image 6
Jenn-Air JMD2124 manual Clock, Start, Add 1 Minute, Stop/Clear, Timer, Tones, Control Lock, Setup, Demo Mode, Help