Jenn-Air JTO500 manual Changing The Accent Base, Before Changing the Accent Base

Changing The Accent Base

WARNING

Injury Hazard – Unplug toaster before performing this operation. Failure to do so can result in injury

Before Changing the Accent Base

Make sure that the toaster is completely turned off. The START/STOP button should not be illuminated. Unplug the power cord from the wall outlet and remove the cord from the toaster; set aside. Remember that the toaster and crumb tray will be hot immediately following a toasting cycle. Always allow the toaster to cool before cleaning or changing the accent base. It is recommended that the crumb tray be emptied after each use and before performing this operation.

How to Change the Accent Base

1. Empty the crumb tray and reinsert. Place a soft hand towel on a solid, level surface. Place the toast- er on its top, slots facing down on the towel. (Note: A few residual crumbs may fall from the slots.)

2.Locate the four rubber feet on the underside of the toaster.

3.Loosen each of the feet by turning counter- clockwise by hand.When all four feet are

completely removed, lift off the accent base and carefully set aside.

4. Position the new accent base on the toaster body and secure it to the toaster by re-installing the four feet.Turn the feet clockwise and tighten each by hand until snug.

NOTE: The feet are designed to be tightened by hand only. DO NOT ATTEMPT TO OVERTIGHTEN USING TOOLS. Attempting to do so can damage

the feet.

5.Position the toaster right side up on the countertop resting on its feet. Set the hand towel aside. Reinsert the detachable power cord.

12