Jenn-Air W10197059B Install Cooktop, Make Electrical Connection, Electrical Connection Options

Install Cooktop

1.Using 2 or more people, place cooktop right side up into the cutout.

NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from the cutout to avoid scratching the countertop.

2.For island or peninsula installations, go to “Rotate Blower - Optional” section.

3.Connect blower exhaust scroll to ducting.

4.Use vent clamps to secure the ducting to the blower exhaust scroll.

5.Reinstall removable grease filter.

6.Reinstall vent grille.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Electrical Connection Options

If your home has:	And you will be	Go to Section:
	connecting to:
4-wire	A fused	4-Wire Cable from
	disconnect or	Power Supply
	circuit breaker
	box
½"
(1.3 cm)
3-wire	A fused	3-Wire Cable from
	disconnect or	Power Supply
	circuit breaker
	box

½"

(1.3 cm)

4-Wire Cable from Home Power Supply to 4-Wire Cable from Cooktop

IMPORTANT: Use the 4-wire cable from home power supply in the U.S. where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction, and in Canada.

Use 8 gauge copper wire.

Electrically ground cooktop.

Failure to follow these instructions can result in death, fire, or electrical shock.

This cooktop is manufactured with the frame connected to the bare ground wire. Connect the cooktop cable to the junction box through the UL listed or CSA approved conduit connector.

1.Disconnect power.

2.Remove junction box cover, if present.

3.Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved conduit connector.

4.Tighten screws on conduit connector if present.

5.See “Electrical Connection Options Chart” to complete installation for your type of electrical connection.

A

B

C

D

A. Cable from home power supply B. Black wires

C. Bare ground wires

D. 4-wire cable from cooktop E. Junction box

E

F

G

H

I

F. White wires

G. UL listed wire connector H. Red wires

I. UL listed or CSA approved conduit connector

1.Connect the 2 black wires together using the UL listed wire connectors.

2.Connect the 2 red wires together using the UL listed wire connectors.

3.Connect the 2 white wires together using the UL listed wire connectors.

4.Connect the green (or bare) ground wire from the cooktop cable to the green (or bare) ground wire (in the junction box) using the UL listed wire connectors.

5.Install junction box cover.

10