Dell E06S001 Panel is not, Installed, Code update, Loaded for Processor n, Mismatch. PSU

Message	Causes	Corrective Actions
Warning: Control	The control panel is not	Install the control panel, or
Panel is not	installed or has a faulty cable	check the cable connections
installed.	connection.	between the display module,
		the control panel board, and
		the system board. See
		"Control Panel Assembly" on
		page 163.
Warning! No micro	Micro code update failed.	Update the BIOS firmware.
code update		See "Getting Help" on
loaded for		page 203.
processor n.

Warning! Power	The system configuration of
required exceeds	processor(s), memory
PSU wattage.	modules, and expansion
Check PSU and	cards may not be supported
system	by the power supplies.
configuration.
Warning!
Performance
degraded. CPU and
memory set to
minimum
frequencies to
meet PSU wattage.
System will
reboot.

If any system components were just upgraded, return the system to the previous configuration. If the system boots without this warning, then the replaced component(s) are not supported with this power supply. If Energy Smart power supplies are installed, replace them with High Output power supplies to use the components. See "Power Supplies" on page 154.

Warning! PSU	A High Output power supply
mismatch. PSU	and an Energy Smart power
redundancy lost.	supply are installed in the
Check PSU.	system at the same time.

Install two High Output or two Energy Smart power supplies in the system.

You can also run the system on one power supply until you can obtain two power supplies of the same type. See "Troubleshooting Power Supplies" on page 179.

58

About Your System