Dell E06S001 Bios Update, Attempt Failed, Nvramclr jumper is installed on system board, Minimum

Message	Causes	Corrective Actions
BIOS Update	Remote BIOS update	Retry the BIOS update. If
Attempt Failed!	attempt failed.	problem persists, see
		"Getting Help" on page 203.

Caution!

NVRAM_CLR jumper is installed on system board.

NVRAM_CLR jumper is installed in the clear setting. CMOS has been cleared.

Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure 6-1 for jumper location. Restart the system and re-enter the BIOS settings. See "Using the System Setup Program and UEFI Boot Manager" on page 63.

CPU set to	The processor speed may be	If not an intentional setting,
minimum	intentionally set lower for	check any other system
frequency.	power conservation.	messages for possible causes.
CPUs with	Mismatched processors have	Ensure that all processors
different cache	been installed in the system.	have the same cache size,
sizes detected.		number of cores and logical
CPUs with		processors, and power rating.
		Ensure that the processors
different core
		are properly installed. See
sizes detected!
		"Processors" on page 148.
System halted
CPUs with
different
logical
processors
detected! System
halted.
CPUs with
different power
rating detected!
System halted.

44

About Your System