
Message | Causes | Corrective Actions |
|
|
|
Unable to launch | System halted after F10 | Restart the system and |
System Services | keystroke because System | update the Lifecycle |
image. System | Services image is either | Controller repository to the |
halted! | corrupted in the system | latest software to restore full |
| firmware or has been lost due | functionality. See the |
| to system board replacement. Lifecycle Controller user | |
|
| documentation for more |
|
| information. |
| The iDRAC6 Enterprise card | Restore the flash memory |
| flash memory may be | using the latest version on |
| corrupted. | support.dell.com. See the |
|
| iDRAC6 user's guide for |
|
| instructions on performing a |
|
| field replacement of the flash |
|
| memory. |
|
|
|
Unexpected | Improperly seated memory | Reseat the memory modules. |
interrupt in | modules or faulty | See "Troubleshooting System |
protected mode. | keyboard/mouse controller | Memory" on page 181. If the |
| chip. | problem persists, see |
|
| "Getting Help" on page 203. |
|
|
|
Unsupported CPU | Processor(s) is not supported | Install a supported processor |
combination. | by the system. | or processor combination. |
Unsupported CPU |
| See "Processors" on page 148. |
|
| |
stepping detected.
Warning: A fatal A fatal system error occurred error has caused and caused the system to
system reset! reboot. Please check the system event log!
Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 173 for any faulty components specified in the SEL.
About Your System
57