Dell E06S Series, E06S001 owner manual Integrated Storage Controller Card

3Locate the SD card slot on the internal dual SD module and press inward on the card to release it from the slot and remove the card.

4Close the system. See "Closing the System" on page 90.

5Reconnect the system and peripherals to their power sources, and turn them on.

Integrated Storage Controller Card

Your system includes a dedicated expansion-card slot on the system board for an integrated controller card that provides the integrated storage subsystem for your system’s internal hard drives. The controller supports SAS and SATA hard drives and also enables you to set up the hard drives in RAID configurations as supported by the version of the storage controller included with your system.

Removing the Integrated Storage Controller Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 89.

3Remove the I/O card. See "Removing the I/O Card" on page 134.

4Disconnect the cables connected to the storage controller card. See Figure 3-1 for the location of the integrated storage controller card in the system.

5Grasp the card by its edges and lift the card to remove it from the connector on the system board.

6Install the I/O card. See "Installing the I/O Card" on page 135

7Close the system. See "Closing the System" on page 90.

8Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing System Components

143