
Message | Causes | Corrective Actions |
|
|
|
PCIe Training | Faulty or improperly installed | Reseat the PCIe card in the |
Error: Expected | PCIe card in the specified | specified slot number. See |
Link Width is x, | slot. | "Troubleshooting Expansion |
Actual Link Width |
| Cards" on page 189. If the |
is y. |
| problem persists, see |
|
| "Getting Help" on page 203. |
|
|
|
Plug & Play | Error encountered in | Install the NVRAM_CLR |
Configuration | initializing PCIe device; | jumper in the clear position |
Error. | faulty system board. | (pins 1 and 3) and reboot the |
|
| system. See Figure |
|
| jumper location. If the |
|
| problem persists, see |
|
| "Troubleshooting Expansion |
|
| Cards" on page 189. |
Read fault
Requested sector not found.
The operating system cannot read from the hard drive, optical drive, or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.
Replace the optical medium, USB medium or device. Ensure that the SAS backplane, USB, or SATA cables are properly connected. See "Troubleshooting a USB Device" on page 174, "Troubleshooting an Optical Drive" on page 185, or "Troubleshooting a Hard Drive" on page 186 for the appropriate drive(s) installed in your system.
SATA Portx device | There is no device connected Information only. |
not found. | to the specified SATA port. |
54
About Your System