Dell E06S Series, E06S001 owner manual Configuration is, Not optimal, Recommended

Message	Causes	Corrective Actions
The memory	Invalid memory	Ensure that the memory
configuration is	configuration. The system	modules are installed in a
not optimal. The	will run but with reduced	valid configuration. See
recommended	functionality.	"General Memory Module
memory		Installation Guidelines" on
configuration		page 92. If the problem
is: <message>		persists, see
		"Troubleshooting System
		Memory" on page 181.

Write fault

Write fault on selected drive.

Faulty USB device, USB medium, optical drive assembly, hard drive, or hard- drive subsystem.

Replace the USB medium or device. Ensure that the USB, SAS backplane, or SATA cables are properly connected. See "Troubleshooting a USB Device" on page 174, "Troubleshooting an Internal USB Key" on page 183, and "Troubleshooting a Hard Drive" on page 186.

Warning: QPI links operating in Slow Speed Mode.

Warning: QPI link between <Agent X> Port <Y> and <Agent X1> <Port Y1> failed.

Warning: QPI link between <Agent X> Port <Y> and <Agent X1> <Port Y1> degraded to half-width.

The processor has bent pins.

The processor is not properly seated on the processor socket.

Verify that there are no bent pins on the processor. If the processor has bent pins, see "Getting Help" on page 203.

Reseat the processors. See "Removing a Processor" on page 148 and "Installing a Processor" on page 152.

If the problem persists, see "Getting Help" on page 203.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary at support.dell.com/manuals.

About Your System

59