5Close the system. See "Closing the System" on page 90.

6If applicable, reconnect the external cables to the I/O card.

7Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

iDRAC6 Enterprise Card (Optional)

Installing an iDRAC6 Enterprise Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 89.

3Remove the I/O card. See "Removing the I/O Card" on page 134.

4Remove the plastic filler plug for the iDRAC6 Enterprise port from the I/O card.

5Align the front edge of the card with the two front plastic retention standoffs next to the iDRAC6 connector on the system board, and lower the card into place. See Figure 3-25.

When the front of the card is fully seated, the plastic standoffs snap over the edge of the card.

136

Installing System Components

Page 136
Image 136
Dell E06S001, E06S Series owner manual IDRAC6 Enterprise Card Optional, Installing an iDRAC6 Enterprise Card