Removing an iDRAC6 Enterprise Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2If applicable, disconnect the Ethernet cable from the iDRAC6 Enterprise Card connector on the system back panel. See Figure 1-3.

3Open the system. See "Opening the System" on page 89.

4Remove the I/O card. See "Removing the I/O Card" on page 134.

5If applicable, remove the VFlash media card from the iDRAC6 Enterprise Card. See "Removing a VFlash Media Card" on page 139.

6Pull back slightly on the two tabs at the front edge of the card and gently lift the front edge of the card off of the retention standoffs.

As the card releases from the standoffs, the connector under the card disengages from the system board connector.

7Install the plastic filler plug over the port on the I/O card.

8Install the I/O card. See "Installing the I/O Card" on page 135.

9Close the system. See "Closing the System" on page 90.

10Reconnect the system and peripherals to their power sources, and turn them on.

138

Installing System Components

Page 138
Image 138
Dell E06S001, E06S Series owner manual Removing an iDRAC6 Enterprise Card