17If applicable, install the memory-riser blanks. See "Installing a Memory- Riser Blank" on page 100.

18Close the system. See "Closing the System" on page 90.

19Reconnect your system and peripherals to their electrical outlets, and turn on the system.

Power Supplies

Your system supports the following power supply modules:

1100 W (high output power supply)

750 W (energy smart power supply)

When a 10 Gb I/O card is installed, the system must have at least two power supplies connected to an A/C power supply. The system requires two power supplies to provide standby power to the system. With a 1 GbE I/O card, only one PSU is required to provide standby power to the system. Table 3-4 and Table 3-5 lists the power supply redundancy modes for a 10 Gb I/O card and a 1 GbE I/O card.

Table 3-4. Power Supply Redundancy Modes With a 10 Gb I/O Card

Number of Power Supplies

Redundancy Mode

System Configuration

 

 

 

1

1+0*

Non-redundant

 

 

configuration with inactive

 

 

SFP+ ports

2

2+0

Non-redundant

 

 

configuration

3

2+0

Non-redundant

 

 

configuration

4

2+2

Redundant configuration

* indicates that the system operates with a limited load.

154

Installing System Components

Page 154
Image 154
Dell E06S001, E06S Series owner manual Power Supplies, Power Supply Redundancy Modes With a 10 Gb I/O Card