
2Remove the processor from the packing material by the processor’s edges only. Do not touch the bottom of the processor. Handle the processor carefully with your fingers on the side edges. Place your hand beneath the processor when you are moving it to the system.
3Locate the pin 1 indicator on the system board socket.
4Locate the pin 1 indicator on the top of the processor. The pin 1 indicator is shown as a triangle on the top of the processor. See Figure
CAUTION: Positioning the processor incorrectly can permanently damage the system board or the processor. Be careful not to bend the pins in the socket.
5Place the processor over the socket with each pin 1 aligned and level. See Figure
6Align the notches in the processor with the socket keys on the ZIF socket. See Figure
7Install the processor in the socket. Keep the processor level (see Figure
8Verify that the processor is properly aligned and seated.
9Close the processor shield. See Figure
10Rotate the
11Using a clean
CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.
12Open the grease applicator included with your processor kit and apply all of the thermal grease in the applicator to the center of the topside of the new processor.
13Place the heat sink on the processor. See Figure
14Close the
15Install the cooling fan assembly. See "Installing the Cooling Fan Assembly" on page 120.
16Install the memory risers. See "Installing a Memory Riser" on page 101.