RAID Battery

The information in this section applies only to systems with the optional PERC controller card.

Removing a RAID Battery

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 89.

3If applicable, remove the memory-riser blanks. See "Removing a Memory- Riser Blank" on page 99.

4Remove the memory risers. See "Removing a Memory Riser" on page 100.

5Remove the memory-riser guide. See "Removing the Memory-Riser Guide" on page 106.

6Pull back gently on the right edge of the battery carrier and lift the RAID battery from the battery carrier. See Figure 3-28.

7Disconnect the RAID battery cable from the RAID battery.

146

Installing System Components

Page 146
Image 146
Dell E06S001, E06S Series owner manual Removing a RAID Battery