Dell E06S001, E06S Series owner manual Installing a Power Supply, Cable retention bracket

Figure 3-32. Removing and Installing a Power Supply

1 2

3

1	power supply	2	locking tab
3	cable retention bracket

Installing a Power Supply

1Verify that power supplies are the same type and have the same maximum output power.

NOTE: The maximum output power (shown in watts) is listed on the power supply label.

2If applicable, remove the power supply blank. See "Removing the Power Supply Blank" on page 157.

3Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure 3-32.

NOTE: If you unlatched the cable management arm in step of the previous procedure, relatch it. For information about the cable management arm, see the system’s rack documentation.

4Connect the power cable to the power supply and plug the cable into a power outlet.

156

Installing System Components