Dell E06S001, E06S Series owner manual Internal USB Memory Key, Installing the Cooling Fan Assembly

Installing the Cooling Fan Assembly

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Align the tabs on the cooling fan assembly with the slots on the system. See Figure 3-17.

NOTE: You must also ensure that the pins on the bottom of the cooling fan assembly are aligned with the holes on the system board.

2Insert the cooling fan assembly into the system and lower the handles to lock it in place.

3Install the cooling fans. See "Installing the Cooling Fan Assembly" on page 120.

4Install the memory risers. See "Installing a Memory Riser" on page 101.

5If applicable, install the memory-riser blanks. See "Installing a Memory- Riser Blank" on page 100.

6Close the system. See "Closing the System" on page 90.

7Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Internal USB Memory Key

An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. The USB connector must be enabled by the Internal USB Port option in the Integrated Devices screen of the System Setup program.

To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in the System Setup program.

120

Installing System Components