Installing the Memory-Riser Guide

1Align the memory-riser guide with the slots on the chassis.

2Lower the memory-riser guide into the system until the tabs click into place.

3Install the memory risers. See "Installing a Memory Riser" on page 101.

4If applicable, install the memory-riser blanks. See "Installing a Memory- Riser Blank" on page 100.

5Close the system. See "Closing the System" on page 90.

6Reconnect the system and peripherals to their power sources, and turn them on.

Hard Drives

All drives connect to the system board through the SAS/SATA backplane board. Hard drives are supplied in special hot-swappable drive carriers that fit in the hard-drive bays.

CAUTION: Before attempting to remove or install a drive while the system is running, see the documentation for the SAS controller card to ensure that the host adapter is configured correctly to support hot-swap drive removal and insertion.

CAUTION: Do not turn off or reboot your system while the drive is being formatted. Doing so can cause a drive failure.

NOTE: Use only drives that have been tested and approved for use with the SAS/SATA backplane board.

When you format a hard drive, allow enough time for the formatting to be completed. Be aware that high-capacity hard drives can take a number of hours to format.

Installing System Components

107

Page 107
Image 107
Dell E06S Series, E06S001 owner manual Hard Drives, Installing the Memory-Riser Guide