Installing the Internal Dual SD Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 89.

3Remove the I/O card. See "Removing the I/O Card" on page 134.

4Align the card with the plastic retention standoffs on the I/O card, and lower the card into place. See Figure 3-25.

When the front of the card is fully seated, the plastic standoffs snap over the edge of the card.

5Connect the SD module cable to the connector on the I/O card.

6Install the I/O card. See "Installing the I/O Card" on page 135.

7If applicable, install the SD card(s). See "Installing an Internal SD Card" on page 142.

8Close the system. See "Closing the System" on page 90.

9Reconnect the system and peripherals to their power sources, and turn them on.

Installing System Components

141

Page 141
Image 141
Dell E06S Series, E06S001 owner manual Installing the Internal Dual SD Module