Dell E06S Series Alert! Power, Required exceeds, System boot, Alert! Redundant, Memory disabled

Message	Causes	Corrective Actions
Alert! Power	The system configuration of	If any system components
required exceeds	processor(s), memory	were just upgraded, return
PSU wattage.	modules, and expansion	the system to the previous
Check PSU and	cards may not be supported	configuration. If the system
system	by the power supplies.	boots without this warning,
configuration.		then the replaced
Alert!		component(s) are not
		supported with this power
Continuing
		supply. If Energy Smart
system boot
		power supplies are installed,
accepts the risk
		replace them with the High
that system may
		Output power supplies to use
power down
		the components. See "Power
without warning.
		Supplies" on page 154.
Alert! Redundant	Memory Mirroring was	Check the memory modules
memory disabled!	enabled in the system setup	for failure. See
Memory	program, but the current	"Troubleshooting System
configuration	configuration does not	Memory" on page 181. Reset
does not support	support redundant memory.	the memory setting, if
redundant	A memory module may be	appropriate. See "Using the
memory.	faulty.	System Setup Program and
		UEFI Boot Manager" on
		page 63.
Alert! System	An error caused the system to	Check other system
fatal error	reboot.	messages for additional
during previous		information for possible
boot.		causes.
BIOS	System is in manufacturing	Reboot to take the system
MANUFACTURING	mode.	out of manufacturing mode.
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.

About Your System

43