Kenmore Kitchen Grill manual Steak Grill no, To Install, To Clean Steak Grill

cooking on top o

STEAK GRILL NO. 49924

INSTALLING AND REMOVING

PLUGJN STEAK GRILL

The steak grill module can be used on either side or you can use two steak grills,,

NOTE

The plug-in heating element is used when cooking with the grill, Separate front and rear heating units are controlled by setting one or both surface unit controls_

CAUTION

Be sure the switch is turned OFF and the module is coo! before removing.

NOTE: To eliminate smoke during grilling, a range vent hood must be used (See Page 10),

Grill

Grates

Heating

Etement

Grease

Shield

Module

Pan

TO INSTALL

1_ Place module pan into the empty wetl with the opening towards the terminat block (See Step 1).

2.Next, place the grease shield inside the module pan (See Step 2).

3o Grasp the heating element with both hands and ptug into receptacle (See Step 3), Lower into

place Make sure cross member supports of heating element rest on ledges of module pan

4, Place the two grill grates on top (See Step 4)

TO REMOVE

1. Lift the grill grates off the top (See Step 4)

2, Grasp the heating element with both hands, Jifting slightly Pull toward you to unplug the heating ele- ment (See Step 3)

3.Lift grease shield from module pan (See Step 2)

4o Lift module pan out of the cooktop Remove as directed to avoid spills of fat drippings Clean all parts after each use

TO CLEAN STEAK GRILL

DO NOT PUT GRILL COMPONENTS IN THE OVEN FOR SELF-CLEAN. COMPONENTS WiLL DISTORT AT THE

HIGH TEMPERATURE Wash the module pan and grease shield in warm, soapy water with a plastic scour-

e

Step1

Step

Step 3

Step 4

ing pad Clean after each use Wash grill grates in warm, soapy water For tough spots use a mild abrasive cleaner Be careful not to damage

STEAK GRILL HINTS AND TIPS

1o Cooking on the grill can produce spattering, It is important to c_ean a_l parts after each use If not cleaned, fat drippings can become rancid

2.The heating element for the grill, tike the surface units, cleans itself It must not be immersed in water

3.Take grill apart to clean and to remove and store 4, To help eliminate smoke during grilling, a hood is

recommended

5, Most utensils which are safe for use on an out-door grill may be used with your Grill Module

NOTE: Some f]are.ups may occur while you are cooking Flare-ups are caused by the iuices hitting the heating element Flare-ups and resulting smoke give foods their deliciOUS flavor and appearance Should excess flaring occur, remove food from grilt and turn Control Knob to OFF Never spray water on a flare-up