Kenmore Kitchen Grill manual CAUTnON, Remove Clips and Tape -- Remove

CAUTnON

Read	thefottowing		information	carefully		Failureto
do so	could cause		a malfunction		of the	range and
result	in	death,	serious	bodily	injury	and/or
property		damage

ELECTROOAL SUPPLY

1 You must provide an adequate electrical supply outlet as required for your range Check with

Iocal utility for governing electrical codes and

ordinances. In the absence of local electrical codes, the National Electrical Code, NFPA No.

70, governing electric range installations must

be followed A copy of the National Electrical Code, NFPA No 70, can be obtained by writing

to: National Fire Protection Association, 470 Atlantic Avenue, Boston, Mass. 0221Q

2 Have the electrical wiring and hookup done by a

competent electrician A three-wire, single- phase, A C. !20/240 volt (or 120/208 volt for dua! rated models),60 Hertz electrical system (properly

fused to meet NFPA No.. 70) must be provided. Range curcuit should be fused with a 40 amp fuse.

Use size No 8copper wire (min)for making the

range line connections DO NOT USE ALUMINUM WIRE If smaller wire sizes are used the range

efficiency wilt be reduced and a fire hazard may be created

If the electrical supply system must have an

ungrounded neutral, remove the ground strap from the neutral of the junction block Fasten the neutral to the junction block neutral and use the screw from the ground strap to fasten the separate ground wire to the unit The ground wire should be a No 10 gauge wire secured to the range ground screw and to a cold water' pipe or other suitable ground

Unplug the range from wall outlet or otherwise interrupt the source of electricity when attempt- ing to repair or service the range Failure to do this could result in a rata1 shock

RANGE INSTALLATOON

POWER -- Power is connected to the junction block located at the lower back of range,

Junction Block -- Remove three screws from bottom wire cover and remove cover showing junction block

Terminal Leads -- Connections to the range

carl be made with a three-wire range cord or with wires enclosed in a flexible or rigid conduit Right under the junction block is the entrance

hole for connection of flexible conduit

REMOVE CLIPS AND TAPE -- Remove

the shipping clips holding the surface units in place.

CAUTION -- Before using your oven be sure

cardboard and tape are removed. The four screws used to anchor' the range to the wood

shipping base must be removed. These screws must be replaced to be used later for leveling

your range Destroy afl cartoning materials like

cardboard and plastic bags. Such materials,

when used by small children, can become air tight chambers if placed over their heads.

JUNCTION

GROUND

GROUND

RAISE

RANGE

26