COiL MODULE REMOVAL AND REPLACEMENT

the "OFF" position and the modules are cool b Make sure all Surface Unit Control Knobs are in l before removing or replacing.,

To remove or replace Surface Unit Modules

. To remove:

oLift module using the handle at the front (See Step t) Raise front just high enough to grasp at front edge

o Ease module toward you using both hands to unplug it (See Step 2 )

o Lift module out of cooktop All modules may be used in either cooktop position (_eft or right)

,To replace:

°Grasp module with both hands (See Step 2)

Ease it into place, align the module terminal with the receptacle on the cooktop (See Step 3.)

=Lower the module, using the handle on the front (See Step 1 )

modume

Step I

/

Receptacle

Terminal

Step 2

Step 3

SURFACE UNiT REMOVAL FOR CLEANING

CAUTION: Be sure the switch is turned off and the element is cool before removing elemenL

The surface units can be unplugged and removed for easier c_eaning of the cooktop

When removing, tilt surface unit upward slightly to clear reflector bowl and pull away from terminal block Sur- face unit will not sit level, when replaced, if it is forced too far upward when removing DO NOT put unit in water to clean it! It will clean itself when heated during normal cooking use Lift out the chrome reflector bowis for cleaning,

Place ciean reflector bowls into cooktop making sure the terminal block is open and showing Slide surface unit into terminal block and lower into reflector bowl

CAUTION: Do not attempt to operate surface elements unless reflector bowls are in place Failure to do this will cause scorching of cooktop, burning of wiring insulation and toss of energy

Page 7
Image 7
Kenmore Kitchen Grill manual Modume, COiL Module Removal and Replacement, To remove or replace Surface Unit Modules, Step