INSTALLATION INSTRUCTIONS
Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and for local electrical inspector’s use, if required.
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install compactor. Failure to do so can result in back or other injury.
IMPORTANT:
■Do not grasp console to move compactor.
■Begin in the room where the compactor will be located.
1.Remove compactor from shipping carton. Remove all packaging materials such as tape and shipping pads. Use a mild detergent and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see “Cleaning.”
2.Be sure the power cord is attached to the cord clip on the rear of the compactor.
A
A. Cord clip
3. Place the 2 corner posts from the carton on the floor near the |
compactor. Open the compactor drawer and remove any |
shipping materials or other items from the drawer. Do not |
remove the compactor bag. Grasp the handle and raise the |
front of drawer until it clears the drawer stops. Grasp sides of |
4.Place the other 2 corner posts on the floor to the side of the compactor. Grasp the sides of the compactor cabinet and put compactor on its side on top of the corner posts. Remove the shipping base from the bottom of the compactor.
A
B
A. Leveling legs
B. Shipping base
Location Requirements
Product dimensions
34¹⁄₈"
(86.7 cm)
15"24"
drawer and lift drawer out of compactor. Place the drawer on |
the 2 corner posts. |
(38.1 cm)
(61 cm)
4
