Cabinet-front mounting
A
C
B 
D
A. Mounting clip
Installation
1.Remove the 2 rubber bumpers from the lower corners of the inside drawer front. Set aside the bumpers and discard the screws.
2.Align the bottom of the custom panel with the bottom of the exterior drawer front and rest the panel on the rest tab.
NOTE: The bottom of the custom panel should not extend below the bottom rest tab at the lower center of the exterior drawer front.
3.Secure the custom panel to the exterior drawer front by using four #8 x 1" wood screws from the inside drawer front.
4.Attach a 15" x ¹⁄₂"
B.Cabinet
C.Retaining bracket
D.Mounting screw
7.Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so drawer will go over drawer stops. Close drawer. Check that the drawer opens freely. If the toe plate rubs against floor, see “Adjusting the Toe Plate” for further instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:
A
B 
C 
D
D
1.Mark on each side of the toe plate the amount of toe plate that rubs the floor covering.
2.Remove the drawer from the compactor. (See Step 3 in the “Unpacking” section.)
3.Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate.
4.Use scissors or utility knife to cut toe plate along line.
5.Replace drawer. If toe plate still rubs floor covering, repeat steps
Installing a Custom Panel
Dimensions
Use these dimension drawings to create a custom panel for use without a trim kit. The panel should be a minimum of ¹⁄₂" (13 mm) thick.
29 ³⁄₈"
(74.6 cm)
15" 
(38.1 cm)
A. Custom panel
B. 15" x ¹⁄₂" quarter round C. Drawer front
D. Four #8 x 1" wood screws placement
7
