Rear Mounting - Blower Motor
NOTE: Optional blower motor rear mounting position (opposite side) for island cabinet locations. The blower motor box assembly can be moved to the opposite side (rear) of the vent box.
1.Remove 7 screws from the mounting flanges of the blower motor box.
Front View
| A |
A | A |
| |
C | B |
A. Screws (7)
B. Keyhole slot shoulder screws (2)
C. Blower motor box
2.Lift blower motor box off the shoulder screws in the keyhole slots. Disconnect wire connection from blower motor and set blower motor box aside.
3.Remove 6 screws from the mounting flange of the ¼" (6.4 mm) deep cover.
Rear View
C | A |
| B |
A. Screws (6)
B. Keyhole slot shoulder screws (2)
C. ¼" (6.4 mm) deep cover
4.Lift the ¼" (6.4 mm) deep cover off the shoulder screws in the keyhole slots and set the cover aside.
5.Remove the screws from the wire mounting plate.
A 
A
BC
A.Screws
B.Wire mounting plate
C.Blower motor box
6.Hold the wire mounting plate and push the grommet out of the mounting plate.
A
B
A. Wire mounting plate
B.Grommet
7.Slide the wire assembly through the slot in the wire mounting plate to remove it.
8.Place the wire assembly through the opening to the opposite side of the vent box.
9.Reassemble the wire assembly and grommet to the wire mounting plate.
10.Install the wire mounting plate to the vent box using the 4 screws previously removed.
11.Place the blower motor box assembly with the keyhole slots over the 2 shoulder screws on the rear of the vent box and reconnect the wire connection to the blower motor.
12.Mount the blower motor box to the vent box and secure using the 6 screws previously removed.
13.Mount the 4³⁄₄" (12.0 cm) cover box (supplied) to the front of the vent box. Place the keyhole slots over the 2 shoulder screws, align the mounting holes, and secure the cover box to vent box using the 6 screws previously removed from the ¼" (6.4 mm) deep cover.
14.Go to the “Complete Installation” section.
11
