![](/images/new-backgrounds/1218236/21823625x1.webp)
Install Griddle
(on griddle models)
The griddle is factory installed.
1.Place drip tray in the well at the front of the griddle. Slide tray toward the back until it stops.
A
B
A. Griddle drip tray
B.Griddle
2.Clean griddle before using. Refer to the Use and Care Guide.
Electronic Ignition System
Install Burner Heads and Caps
Install the burner head, making sure the alignment pins are properly aligned with the burner base. Place burner cap (black) on top of the burner head.
20,000 Btu/h Ultra Power™
Burner
A
A. Incorrect
B. Correct
B
15,000 Btu/h Professional Burner
A
A. Incorrect
B. Correct
B
5,000 Btu/h Simmer/Melt Burner
A
A. Incorrect
B. Correct
B
Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to any position, the system creates a spark to light the burner. This sparking continues until the flame is lit or the knob is turned to Off.
Check Operation of Cooktop Burners
Push in and turn each control knob to the “LITE” position.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs to OFF.
If burners do not light properly:
■Turn cooktop control knob to the “OFF” position.
■Check that the range is plugged in and the circuit breaker has not tripped or the fuse has not blown.
■Check that the gas shutoff valves are set to the “open” position.
■Check that burner caps are properly positioned on burner bases.
Repeat
Flame Height
The cooktop flame should be a steady blue flame approximately ¼" (0.64 cm) high.
Dual Flame Burner
A
B
A. Upper flame
B. Lower (simmer) flame
Single Flame Burner
To Adjust Flame Height:
1.Unplug range or disconnect power.
2.Remove burner grates.
3.Remove the control knobs.
4.Open the oven door and remove the 2 screws on each side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control console will not rest in the side brackets properly once it is detached.
13