5Apply sealant to holes and attach base using the included hardware.
6Apply sealant to 3 screws, fill coax hole, connect coax to antenna and wrap connection with insulating electrical tape. Coax connection should be located inside vertical stalk of antenna for service.
7Attach antenna to base and seal all seams and screws on plate and antenna base.
8Install interior plate using included hardware over hole in ceiling.
ASA ELECTRONICS CORPORATION
www.jensenrvdirect.com
www.asaelectronics.com
© 2010 ASA Electronics Corporation
Refer to the ANHD20 Installation/Operation for additional installation details.
9Remove plate from wall and disconnect all wires and cables (note power/ground polarity & cable labels).
10Connect appropriate cables / wires and install new plate. Tape all coax connections.
