#cd /tmp

#mt rew

#cpio -ivdumB < /dev/rmt/0mn

#./UNINSTALL

Configuration of the StarKeeper II NMS

StarKeeper II NMS

c. Enter i Return when you see the following:

Connections for L60 must either be removed or made inactive.

If you are upgrading L60 you should make the connections inactive, otherwise connection information will have to be re-entered.

Enter "r" to remove, or "i" to make inactive: i

d. Remove the diskette or tape from the drive.

5. Enter the package installation command and follow the instructions:

For 6386

Enter /usr/bin/installpkg; then enter F to install the

Hardware

floppy diskette. Insert the floppy diskette labeled LCS60

 

Network Interface for Ethernet R3.0 StarKeeper® NMS RX.Y

 

Support for AT&T 6386 into the disk drive when instructed

 

to do so.

For HP

Insert the tape labeled LCS60 Network Interface for Ethernet

Hardware

R3.0 StarKeeper® NMS RX.Y Support for Hewlett-Packard

 

into the tape drive and wait until the light stops blinking.

 

Then execute the following four commands:

#cd /tmp

#mt rew

#cpio -ivdumB < /dev/rmt/0mn

#./INSTALL

Issue 3

B-3

Page 283
Image 283
HP LCS60 manual Enter i Return when you see the following, Enter /usr/bin/installpkg then enter F to install, To do so