Installing the LCS60

Connecting the Fiber Interface

Connection to the data switch network for data communications is by means of a dual optical fiber cable. The network LCS60 fiber connection must be to a CPM- HS module in a Datakit II VCS or BNS.

For network connection follow the steps below:

Routing the Optical Fiber Cable

The optical fiber cable may be run in suspended ceilings, subfloor cable runs, and riser shafts up to 500 feet. Before routing the cable, connect rubber caps to each end of the cable to protect it from dirt and dust during installation.

Note: Tools and hardware used to install copper wire and cable in building duct and conduit systems are satisfactory for use in installing optical fiber cable (such as, fish wire, woven cable grips, or rope). If woven cable grips are used with fiber optic cables, tape them to the cable jacket before pulling the cable.

When routing the cable, keep it away from copper riser cables. If this is not pos- sible, install an inner liner (conduit or innerduct) to keep the cables separated. EFT corrugated tubing (or equivalent) can be used; this tubing comes in short lengths and can be bent.

Caution: Optical fiber cables are not intended for use in air-handling ceiling areas unless installed in approved conduit.

When installing the cable, avoid tight pulls or tugs against sharp corners of framework. If cables are to be installed around sharp edges of cabinetry or framework, cover the edges with split tubing or similar material. Observe the minimum bending radius and maximum pulling tension specifications when routing the dual optical fiber cables. When lacing or securing the cable, use flat lacing twine or cable ties and do not tie the cable too tightly or microbending losses may occur. Bundles of cables should not hang or protrude into the work space. Wrap the cables in loops not less than 6 inches in diameter.

The optical fiber cable is not designed for conduit installation, but can be installed in conduit if:

Hardware

Issue 3

2-19