Introduction

LCS60 Software

Verify that the following procedures have been followed:

1. The LCS60 is securely mounted as described in Chapter 2.

2. There is a fiber pair connection between the LCS60 and the CPM-HS module in the data switch node.

3. A grounded power cord is attached to the power input jack on the rear panel of the LCS60.

4. An RS-232 connection exists between the rear console port of the LCS60 and one of the following:

Modem

TY-12 port on the data switch node

Directly connected terminal.

Preliminary Configuration Requirements

Before configuring the LCS60, you must have the following information on hand:

nodename of the LCS60

IP and IPX addresses for the ethernet

IPX frame type for ethernet

protocols and services the LCS60 will be using

the number of sessions required for each protocol

the default route

the Domain Name Service (if DNS is to be used)

the SNMP manager (if SNMP is to be used)

IP and IPX addresses for virtual networks (if remote access is to be used)

AppleTalk address and zone name for the AppleTalk virtual network (if AppleTalk is to be used)

3-2

Issue 3