HP LCS60 Switch. Try manually restarting the interface, Cleared

Error Messages

	switch. Try manually restarting the interface.
RX-MUTE	The optical connection between the receiver on the VMEDKHS
	board in the LCS60 and the transmitter on the CPM-HS paddle
	board at the data switch has been broken. Verify that the CPM-
	HS is properly installed in the data switch slot and that there is
	optical connectivity between the LCS60 and the CPM-HS. The
	interface will recover automatically when the condition has been
	cleared.
TX-HANG	The transmitter on the VMEDKHS board in the LCS60 has
	stalled and is no longer able to send data to the data switch net-
	work through the CPM-HS. Verify that the CPM-HS is properly
	installed in the data switch slot and that there is optical connec-
	tivity between the LCS60 and the CPM-HS. Also verify that the
	CPM-HS is in service. The interface will recover automatically
	when the condition has been cleared.
TX-FULL	The transmitter on the VMEDKHS board in the LCS60 has
	apparently stalled and data is no longer draining to the data
	switch network through the CPM-HS. This condition should be
	detected as a TX-HANG error unless the administrator has dis-
	abled stall detection by modifying dkhs tunable parameters. Try
	manually restarting the interface.

dkhs0: Interface Restarted

This message indicates the interface has automatically restarted after a previ- ously detected error.

NOTICE: dkhs0: Hardware Reset Failed

This message indicates that an attempt to reset the board by means of the dkmaint command has failed.

If an error message is received, the administrator should check the CPM-HS module, hardware, and fiber link connections, and execute the dkmaint com- mand to reset the interface.

Administration

Issue 3 8-43