HP LCS60 manual Asynchronous Terminal Data Switch

Installing the LCS60

Hardware

Note: There are small variations in system prompts and responses depending on the release of the Lucent Technologies data switch (Datakit II VCS or BNS).

4. Power-up the system console terminal or PC and set the options as directed in Table 2-4.

5. Connect an asynchronous terminal or PC to an asynchronous port on the data switch, using a null-modem connection (D8AG connector). A gender changer may be required depending on the type of RS-232 connector available on the terminal device. Configure the asynchronous port according to Table 2-4 as an originating group. Refer to the appropriate Lucent Technologies data switch Node Reference Guide for complete instructions.

6. Restore both asynchronous ports and name to service.

7. In response to the DESTINATION prompt on the terminal device, enter the name created for the LCS60 console. This step can be done from any ter- minal displaying a DESTINATION prompt. Maintain proper security pre- cautions to guard against unauthorized or accidental usage.

8. Continue with the Connecting Fiber Interface section.

Figure 2-4: System Console Connections – through a Data Switch

Asynchronous
Terminal	Data Switch

DCE

Asynchronous

Port

Console Port

LCS60

2-16 Issue 3