HP LCS60 Table 2-3:Required Additional Equipment, *Formerly AT&T FL2P-P

Site Preparation

EMI Considerations

The LCS60 can radiate radio frequency energy, and if not installed in accordance with instructions, may cause interference to radio communications. This equipment has been tested and found to comply with the limits for a Class A computing device pursuant to Part 15, Subpart J of FCC Regulations, which are designed to provide reasonable protection against such interference when operating in a commercial environment. Operation in a residential area is likely to cause interference, in which case the user must take whatever measures may be required to correct the interference.

Required Equipment

The LCS60 is shipped in the hardware configuration ordered, the operating software loaded, and user documentation included. Additional equipment required for the initial installation of an LCS60 is listed in Table 2-3.

Table 2-3: Required Additional Equipment
___________________________________________________________________
⎜ Quantity		⎜	Item	⎜	Description	⎜
⎜		⎜		⎜		⎜
⎜	1	⎜ Fiber Pair		⎜ Lucent FL2P-P-[length]* (specified in feet)		⎜
⎜	1	⎜ RS-232		⎜ Length required to connect console to		⎜
⎜		⎜	(DB25) Cable	⎜	LCS60	⎜
⎜		⎜		⎜		⎜
⎜	1	⎜ Ethernet Transceiver		⎜ Length required for connection from		⎜
⎜		⎜ (IEEE Cable)		⎜ LCS60 to Ethernet transceiver		⎜
⎜	(as reqd.)	⎜	Horizontal Shelf,	⎜	Rack mounting hardware for additional	⎜
⎜		⎜	Slide Rails, or	⎜	support; provided by rack/cabinet	⎜
⎜		⎜		⎜		⎜
⎜		⎜	support brackets	⎜ vendor.		⎜
⎜ 1 (as reqd.)		⎜ ED5P183-33, G-40		⎜ Wall Mounting Kit for LCS60		⎜
⎜	1	⎜	CPM-HS module	⎜	Node connection	⎜
⎜		⎜		⎜		⎜
⎜	1	⎜ AWJ2		⎜ Paddleboard for the CPM-HS module		⎜
⎜		⎜		⎜		⎜
⎜ (as reqd.)		⎜ wire		⎜ 18 AWG — 6 AWG wire for DC powered unit only		⎜

*Formerly AT&T FL2P-P.

Hardware

Issue 3 2-5