HP LCS60 manual Screen 4-4 Configure AppleTalk Virtual Network Example

LCS60 Configuration and Connection for PPP Service

[ ? for help, q to quit, RETURN for menu ] ==> q

NOTICE: To allow IPX configuration changes to take effect you must first stop and restart the IPX software as follows:

lcsadm -c stop ipx lcsadm -c start ipx

10. Configure the AppleTalk network/zone (atalkas):

Enter atalkas at the Top>Config># prompt or enter config atalkas from the Top directory.

Follow the on-screen instructions for setting up the AppleTalk network number and zone name. (Refer to Screen 4-4.) The virtual AppleTalk address must be defined; it is used for dynamic allocation of AppleTalk addresses for PPP and ARAP clients.

Screen 4-4: Configure AppleTalk Virtual Network – Example

PPP

Top>Config># atalkas

CONFIGURE ADDRESS AND ZONE FOR APPLETALK VIRTUAL NETWORK

1 Configure Address and Zone Name

2 Display Address and Zone Name

3 Delete Address and Zone Name

Enter Menu Selection

[ Type q to quit or ? for help ] ==> 1

*** The AppleTalk virtual network has not yet been configured.

Enter the network number for the LCS60 interface to the AppleTalk network.

This must be a number between 1 and 65279, and must NOT be equal to any other network number in use in the AppleTalk network, and must not be contained within any other network number range in use in the AppleTalk network.

[ Type q to quit ] ==> 2010

Screen 4-4: continued on next page

4-10 Issue 3