HP LCS60 manual Connection through Modems, Connection through StarKeeper II NMS

Installing the LCS60

Connection through Modems

To connect an asynchronous terminal or PC to the LCS60 for use as a system con- sole by means of modems, refer to Figure 2-5 and follow the steps below:

1. Option Serial Port 1 to emulate DTE operation. (Refer to the section Serial Port Optioning earlier in this chapter.)

2. Connect the LCS60 rear panel connector labeled "Serial Port 1" to an asyn- chronous terminal by means of modems using straight-through RS-232 cabling. Modems must operate asynchronously at 9600 bps.

3. Power up the system console and set options as directed in Table 2-4.

4. Continue with the Connecting Fiber Interface section.

Figure 2-5: System Console Connections – through Modems

Asynchronous

Terminal

		DTE
Modem	Modem
			Console
			Port
			LCS60

Hardware

Connection through StarKeeper II NMS

For the StarKeeper II NMS connection (Figure 2-6), follow the steps below:

1. Serial Port 1 should be optioned to emulate DCE operation. This is the default; therefore, if you haven't changed anything there will be no need to change the option.

Issue 3 2-17