Initial Setup

WARNING: "lcsadm" configuration is already in progress. Continuing can cause catastrophic results!

Do you want to continue? [y/n]

Step 7 The lcsadm interface takes you into a hierarchical system of directories and commands. (For example, Screen 3-1.)

Screen 3-1: LCS60 Top Directory

sysV68:Top>

Return

 

 

 

Commands may be abbreviated. Commands are:

 

 

config/

help

manager/

ports/

quit

service/

session/

start

stop

^

!

 

 

 

 

Note: The machine name (shown in Screen 3-1 as sysV68) appears at the beginning of the Top> prompt. The sysV68 will be replaced by the node name you configure for your LCS60 after you exit and then re-enter the lcsadm interface (in the example that follows the prompt would become morse:Top>). The screen displays in this document, however, omit the machine name to avoid confusion.

Note: The directories are followed by a slash "/" in the screen display.

Step 8

To navigate through the directories, enter the name of the directory

 

you wish to access (top, session, ports, service, manager, config). To see

 

the contents of a directory, use the ls command or the Return key.

Step 9

Enter the Config directory by typing config at the Top> prompt.

Note: Command and directory names can be abbreviated by typing a unique string of the beginning characters of the command (e.g., the command backup can be accessed by typing b at the Top>Config># prompt).

Software LCS60

Issue 3

3-5