HP LCS60 manual Ecdm, Hex, Lanc, Mask, Ncr, PCC2, Ramcdi, Rtc, VME2, Passed, Bypass

Processor Diagnostics - MVME197

DP	Display Pass Count
ECDM	ECDM Tests (DIR)
HE	Help on Tests/Commands
HEX	Help Extended
LA	Loop Always Mode
LANC	LAN Coprocessor (Intel 82596) Tests (DIR)
LC	Loop Continuous Mode
LE	Loop on Error Mode
LF	Line Feed Mode
LN	Loop Non-Verbose Mode
MASK	Self Test Mask
NCR	NCR 53C710 SCSI I/O Processor Test (DIR)
NV	Non-Verbose Mode
PCC2	PCCchip2 Tests (DIR)
RAM	Random Access Memory Tests (DIR)
RAMCD	Generic Memory Tests with Data Cache only (DIR)
RAMCDI	Generic Memory Tests with Instruction/Data Cache (DIR)
RTC	MK48T0x Timekeeping (DIR)
SE	Stop on Error Mode
ST	Self Test (DIR)
ST2401	CD2401 Serial Self-Tests (DIR)
VME2	VME2Chip2 Tests (DIR)
ZE	Zero Errors
ZP	Zero Pass Count

Maintenance

Use the st command at the 197-Diag> prompt to run the self-test firmware diagnostics. This will list all tests and status (e.g., PASSED) as it runs. A partial example is shown below:

197-Diag> st
ECDM	REGS: Register Checks	Running --->	PASSED
ECDM	CHKGEN: Checkbit Generation	Running --->	PASSED
ECDM	CHKRAM: Checkbit DRAM Test	Running --->	PASSED
ECDM	SBEC: SBE Control Options	Running --->	PASSED
ECDM	SBEP: SBE Permutations	Running --->	BYPASS
ECDM	DBEC: DBE Control Options	Running --->	PASSED
ECDM	DBEP: DBE Permutations	Running --->	BYPASS
ECDM	INITCK: INIT Function Check	Running --->	PASSED
ECDM	I2C: I2C Bus Interface Check	Running --->	PASSED
BSW	REGS: Register Checks	Running --->	PASSED
BSW	TMR1A: Timer 1 Counter	Running --->	PASSED

Use the sd command to return to the debugger prompt and then reboot as shown:

9-24 Issue 3