HP LCS60 manual # lcsadm, Remote Upgrade Installation Menu

Remote Upgrade

2. Access the Remote Upgrade Installation Menu using lcsadm -c config upgrade or:

#lcsadm

Top># config

Top>Config># upgrade

REMOTE UPGRADE INSTALLATION MENU

CLIENT Procedures:

1.Enable a client to receive a generic download

2.Remove from client the previously installed generic

3.Install on a client the downloaded generic

4.Disable a client from receiving a generic download

..............................................................

SERVER Procedures:

5.Copy (from Tape) a generic onto this server

6.Send a generic from this server to a client

7.Remove a spooled generic from this server

Enter Menu Selection

[ Type q to QUIT or ? for HELP ] ==>

3. You are on the client. Select item 1 and enter the server's call address in the form area/exchange/local when prompted. This authorizes the server to establish the necessary connections.

Note: Do not exit or quit at this time. You will need to perform some additional steps later on throughout this procedure.

4. Log on to the server from the system console as root.

5. Access the Remote Upgrade Installation Menu using lcsadm -c config upgrade.

5. On the server; select item 5 under the SERVER Procedures and answer the prompts accordingly.

Note: A server can only maintain (i.e., spool) one copy of an LCS60 software generic and an LCS60 patch. Therefore, if a copy already resides on the server, this procedure will automatically remove it before copying the newer generic from tape onto disk.

Maintenance

Issue 3 9-17