HP LCS60 manual Configuration Changes, Configuration Commands Config Directory

Configuration Changes

LCS60 Software

A variety of commands are available to review the configuration. Commands such as viewnets and viewhosts are available from the Config directory. Com- mands show, types, and summary are also available to check the current confi- guration before making configuration changes. Refer to Chapter 8 for details of these commands.

The configuration database may be changed at any time by using commands available from the Config directory. Table 3-2 lists the configuration commands.

Table 3-2: Configuration Commands – Config Directory
___________________________________________________________________
⎜ Configuration	⎜	Command	⎜
⎜	⎜		⎜
⎜ Set the date and time	⎜	datetime	⎜
⎜ Change the node name	⎜ nodename		⎜
⎜ Choose the protocols to start when the LCS60 is rebooted	⎜ protocol		⎜
⎜ Change the default route	⎜	dftroute	⎜
⎜	⎜	softwarekey	⎜
⎜ Set the software key	⎜		⎜
⎜ Set the DNS resolver	⎜	dns	⎜
⎜ Change the SNMP configuration	⎜ snmp		⎜
⎜ Change the number of service sessions	⎜ maxsessions ⎜
⎜ Define service ports	⎜	srvports	⎜
⎜	⎜	ipas	⎜
⎜ Configure virtual IP network for PPP and SLIP	⎜		⎜
⎜ Configure IPX addresses for PPP	⎜	ipx	⎜
⎜ Configure virtual AppleTalk network for ARAP and PPP	⎜ atalkas		⎜
⎜ Add a new host to the network	⎜ addhost		⎜
⎜ Add a new network to the LCS60 configuration	⎜	addnet	⎜
⎜	⎜	delhost	⎜
⎜ Remove a host from the network	⎜		⎜
⎜ Remove a network from the LCS60 configuration	⎜	delnet	⎜
⎜ Configure the Ethernet interface	⎜ etherif		⎜
⎜ Configure subnetworks and masks	⎜ subnet		⎜
⎜ Display all hosts on a network	⎜	viewhosts	⎜
⎜	⎜		⎜
⎜ Display all configured networks	⎜ viewnets		⎜

All of these commands are entered at the Top>Config># prompt.

Note 1: For information on configuring multiple IP subnetworks for SLIP or for IP over PPP, refer to Chapter 1 and to the ipas command in Chapter 4 (PPP) or Chapter 5 (SLIP).

3-28 Issue 3