HP manual Assembly, Installing the LCS60, Unpacking, Rack Mounting

Assembly

Hardware

Unpacking

The LCS60 hardware comes fully assembled, with the exception of two handles that mount on the front frame of the enclosure. After opening the shipping con- tainer, remove the documentation package, system software tapes and diskettes and package of loose parts. Carefully remove the LCS60 unit. Open the front cover of the LCS60 and check that the system is equipped as ordered and that all circuit packs are fully seated in the LCS60 card cage.

Installing the LCS60

Follow the appropriate instructions (refer to Figure 2-1) to install the LCS60.

Rack Mounting

Mount the LCS60 in a 19-inch rack or cabinet using compatible mounting hardware as shown in Figure 2-1. Mounting in a 23- or 25-inch rack or cabinet requires a Bracket Extension Kit.

The front frame of the LCS60 has four mounting holes for securing the unit in a standard 19-inch equipment rack. The weight of the LCS60 requires a shelf, slide rails, or a support bracket. Contact the cabinet vendor for compatible hardware. The handles for the LCS60 are shipped in a separate package within the main shipping box. The handles can be attached to the front frame, with the handles pointing away from the LCS60, using the four flat-head machine screws.

To rack mount the unit:

1. Attach either a horizontal shelf, slide rails, or support brackets to the verti- cal uprights of the cabinet. For design compatibility, this hardware should be purchased from the cabinet vendor.

2-6 Issue 3