HP LCS60 manual Protocol and Services Commands, ⎜ Service Command

Initial Setup

Note: You must have the appropriate key to activate the features on your LCS60. The R1 key will activate gateway services and the IP protocol feature, R2 activates the R1 features and the AppleTalk protocol feature, and the R3 key will activate all R2 features and the IPX protocol.

After completing the steps in initsetup, you must complete the configuration of your LCS60 by adding the protocols and services you will be using. Refer to the sections (Configure Protocols and Gateway Services– srvsetup and Configure Default Route, DNS, and SNMP ) below to complete the configuration of your LCS60.

The individual configuration commands are listed in Table 3-1. These com- mands may be run individually from the Top>Config> prompt, or as part of the srvsetup command as noted in Table 3-1.

Table 3-1: Protocol and Services Commands
_______________________________________________________________________
⎜ Service	⎜	Command	⎜	Notes	⎜
⎜	⎜		⎜		⎜
⎜ Define protocols/services	⎜	protocol	⎜	srvsetup	⎜
⎜ Configure the Ethernet Interface	⎜ etherif		⎜ srvsetup		⎜
⎜ Set the default route	⎜ dftroute		⎜ dftroute		⎜
⎜ Configure the Domain Name Resolver	⎜	dns	⎜	dns	⎜
⎜	⎜		⎜		⎜
⎜ Configure the SNMP Agent	⎜	snmp	⎜	snmp	⎜
⎜ Define the maximum LCS60	⎜	maxsessions	⎜	srvsetup	⎜
⎜ and gateway service sessions	⎜		⎜		⎜
⎜ Configure IPX virtual and ethernet addresses	⎜		⎜		⎜
⎜ for PPP sessions	⎜	ipx	⎜	srvsetup, Chap. 4	⎜
⎜	⎜		⎜		⎜
⎜ Configure virtual network for SLIP	⎜		⎜	srvsetup,	⎜
⎜ and PPP services	⎜	ipas	⎜	Chap. 4 and 5	⎜
⎜ Configure virtual AppleTalk	⎜ atalkas		⎜ srvsetup,		⎜
⎜ network/zone for PPP and ARAP services	⎜		⎜ Chap. 4 and 6		⎜
⎜	⎜		⎜		⎜
⎜ Configure TCP-to-Async gateway service (ports)	⎜ srvports		⎜ Chap. 7		⎜

LCS60 Software

Issue 3 3-9