HP LCS60 manual Screen, == Research Lab

LCS60 Configuration and Connection for PPP Service

Screen 4-4: Continued

Enter the zone name to be used by AppleTalk nodes that use the virtual network. The name may contain no more than 32 characters.

[ Type q to quit or ? for help ]

==> Research Lab

You have entered:
VIRTUAL NETWORK NUMBER	2010
VIRTUAL NODE NUMBER	1
VIRTUAL NETWORK ZONE NAME ..	Research Lab
Confirm?
Enter y,n ==> y
The LCS60 virtual AppleTalk network is configured as follows:
VIRTUAL NETWORK NUMBER	<2010>
VIRTUAL NODE NUMBER	<1>
VIRTUAL NETWORK ZONE NAME ..	<Research Lab>

NOTE: Changes to the configuration of the LCS60 virtual AppleTalk network will not take effect until you:

-Enter the lcsadm command and then type 'start atalk' from the top command directory to start AppleTalk protocol.

CONFIGURE ADDRESS AND ZONE FOR APPLETALK VIRTUAL NETWORK

1 Configure Address and Zone Name

2 Display Address and Zone Name

3 Delete Address and Zone Name

Enter Menu Selection

[ Type q to quit or ? for help ] ==> q

Top>Config>#

PPP

Note: Do not use the AppleTalk address shown in the example; follow your corporate AppleTalk address convention.

11. Configure the Ethernet interface (etherif):

Enter etherif at the Top>Config># prompt or enter config etherif from the Top directory.

Follow the on-screen instructions for configuring the ethernet interface. (Refer to the example in Screen 4-5.)

Issue 3 4-11