HP LCS60 PAD, group, address, address, service state, directory entry, security pattern, Configure the CPM-HSModule, This is not used, and receive calls

Installing the LCS60

Hardware

address	This is the IP network security group name. The first address
	entered must be the the same as the node name that is
	assigned to the LCS60 when the LCS60, itself, is subsequently
	configured from the LCS60's system console. Up to four
	security groups may be configured for the LCS60, therefore,
	four corresponding local addresses may be defined.
PAD	This is not used.
directory entry	A 30-character description of the LCS60 in double quotes.
group	Enter the group from the previous operation.
security pattern	The originating group name security feature allows the
	Datakit II VCS to restrict calls for this host to a select group of
	Datakit II VCS originating groups. Since the srvtab files (see
	Appendix A) may also be used to restrict incoming calls,
	Return is used to disable this feature.
service state	The local address must be in service for the LCS60 to originate
	and receive calls.

Configure the CPM-HS Module

CC0> enter cpm

MODULE ADDRESS: 6

COMMENT [up to 60 chars double quoted]:

"fiber interface to LCS60" HARDWARE TYPE [422, hs: +(hs)]: hs NUMBER OF CHANNELS [2-512: +(32)]:512 CONNECT-TIME BILLING [on, off: +(off)]: off

SINGLE OR MULTIPLE GROUP(S) [single, multiple: +(single)]: single

GROUP [up to 8 chars]: morse

ENDPOINT NUMBER OR RANGE [0000-9999, none: +(none)]: none

CC0> restore cpm 6

CC0>

Conduct the dialogue as shown in the screen above.

address	Check the data switch cabinet for the slot number of the
	CPM-HS module to which the LCS60 is connected.
	Enter the slot number of the CPM-HS module. In this
	example the CPM-HS module is in slot 6.

2-24 Issue 3