HP LCS60 manual InterPPP, Connection

PPP Service Examples

Note: Be aware that baud rates are dictated by the application, serial drivers installed, and the version of the PC UART.

InterPPP

Note: InterPPP II is different from InterPPP. Refer to the user documentation for specific details.

The InterPPP software requires minimal Mac configuration for AppleTalk or IP over PPP.

Note: Make sure MacTCP is installed in the Control Panels folder. MacTCP should come with the InterPPP package. TCP/IP should be selected under the MacTCP for the initial connection.

Note: Remember to reselect PPP for the next PPP session.

User Information

Connection

To establish the PPP connection, perform the following steps:

1. From the Network Control Panel of the Control Panels folder select the AppleTalk/PPP icon. (Refer to Figure F-5.) This tells the AppleTalk software to use the serial port instead of the built in LAN port.

2. Launch the InterPPP application.

3. Under File, choose New or Open CCL Script; create/edit and save the script.

4. Under Configure, select Modem (refer to Figure F-6):

—Choose Port; select Modem Port

—Choose Modem; select your CCL script

—Choose After Connect: select StartPPP; then close the window.

5. Under Configure; select PPP: choose the PPP settings (Figure F-6); then close the window.

F-14 Issue 3