HP LCS60 manual Slip Sessions

Incoming Error Messages

Error Messages

SLIP Sessions

The LCS60 may send the following messages to the SLIP user:

<IP address> is out of range

The IP/SLIP client requested an <IP address> on his/her data switch dial- string that was not within the range of the IP network and subnetwork mask associated with the called IP Network Security Group (i.e., the dkserver service name).

<IP address> is reserved

The IP/SLIP client requested an <IP address> on his/her data switch dial- string that has been reserved by the LCS60 administrator. If a user wishes to request his/her own reserved IP address, then he/she should omit the IP address from his/her data switch dialstring.

slip is busy

The SLIP service has reached its maximum allowed number of concurrent sessions or else the user's reserved IP address is in use by another session for the same user. Try again later, or else have the LCS60 administrator raise the limit.

<IP address> is busy

The IP/SLIP client requested an <IP address> on his/her data switch dial- string that has already been allocated to another user.

dkserver <dkserver name> does not have an IP network configured

The IP/SLIP client has called into the LCS60 using <dkserver name> as the data switch dialstring's local component. However, no IP Network Security Group (and therefore no IP network) is associated with that <dkserver name>. This should not happen unless the LCS60 administrator has deleted an IP Network Security Group, the ipas daemon terminates and is restarted, and dkhost is not restarted.

network is down

The SLIP service has been taken out of service by the LCS60 administrator.

C-10 Issue 3