Precor S3.45 manual Assemble Chest Press Weight Stack

S3.45 Assembly and Maintenance Guide

10.Assemble Chest Press Weight Stack

A.Place two Guide Rods into the large holes on the Chest Press side of the Main Base. Use care not to get lubricant from the Rods on your clothing or on other parts of the machine.

B.Place one Weight Cushion on each Guide Rod and allow it to slide down to the top of the Main Base.

C.Apply one tube of lubricant to each Guide Rod. Avoid getting lubricant on your clothing or on other parts of the machine.

D.Add the five 15-lb weights, the ten 10-lb weights, and the five 5-lb weights. Note the tab location for weight stickers (you will attach the stickers later). Hold your finger over the plastic bushing in each weight to prevent the bushing from popping out.

CAUTION: The weights are heavy! Handle

the weights carefully so as not to drop them or injure yourself. Pick up and place one weight at a time onto the Guide Rods. Have someone hold the Guide Rods in place while you slide the weights on the stack.

E.Place the Cap Plate on the Guide Rods with the hole facing toward you. Allow it to slide onto the Weight Stack.

F.Insert the retainer pins of the Side Bracket into the Guide Rods. Attach the Side Bracket to the Top Frame using

one 2¾-inch bolt two washers one locknut Wrench tighten.

		Top Frame
	1 - 2¾" bolt
F 2 - washers
	1 - locknut	Side Bracket
		Retainer Pins
	Guide Rods (2)	A
	Cap Plate	E
	5 - 5-lb Weights				D	Front
D	10 - 10-lb Weights
	5 - 15-lb Weights
					Rear Upright
					Main Base
	B CushionsWeight		(2)
1		2	3	4	5	6

Step 10. Assemble Chest Press Weight Stack

page 19